Date:         Mon, 3 Dec 2018 15:59:04 -0500
Reply-To:     "kenneth wilford (Van-Again)" <kenwilfy@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "kenneth wilford (Van-Again)" <kenwilfy@COMCAST.NET>
Subject:      Re: Antenna replacement
Comments: To: ddbjorkman@verizon.net
In-Reply-To:  <2007958306.1095880.1543867887368@mail.yahoo.com>
Content-Type: text/plain; charset="UTF-8"

Have you taken a look at my video about this?

https://youtu.be/Aqn860kYl-Q

On Mon, Dec 3, 2018 at 3:11 PM ddbjorkman@verizon.net <
ddbjorkman@verizon.net> wrote:

> That's what I am hoping for.  I can break out the mini grinder and adjust
> it.  It would just be nice to have the correct size of the hole before I
> start.
> Dave B.
>
> -----Original Message-----
> From: Stephen Grisanti <bike2vcu@yahoo.com>
> To: ddbjorkman@verizon.net <ddbjorkman@VERIZON.NET>
> Cc: vanagon <vanagon@GERRY.VANAGON.COM>
> Sent: Mon, Dec 3, 2018 3:05 pm
> Subject: Re: Antenna replacement
>
> It's been years since I replaced our '87's antenna and it came out without
> issue. Sounds like that hole is too small but someone else will report with
> measurements, no doubt.
>
> Stephen
>
> Mobile
>
> > On Dec 3, 2018, at 2:57 PM, ddbjorkman@verizon.net <
> ddbjorkman@VERIZON.NET> wrote:
> >
> > Hi All;I am replacing the antenna on my '87 Westy.  The antenna will not
> pull out of the hole it is in.  It's loose, will fall into the space below,
> but won't come out the hole in the body.  I am wondering if old body work
> closed it up.  the hole is 1.135" tall by .585" wide, both at largest
> point.  Is this hole too small??
> > Thanks;Dave B.
>


--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com