I wonder if someone would be so kind as to accurately measure an upper control arm bushing for me? I would like to know: Â Â Â Â Â Â 1,)Â Â Â Â Â The outside dimension (diameter and taper, if there is any) of the outer housing where it press fits into the control arm. Â Â Â Â Â Â 2.)Â Â Â Â the length of the complete bushing from the flange that touches the control arm to the end of the center bushing member. Â Â Â Â Â Â and 3.)Â Â Â Â the diameter of the bolt that holds every thing together.
You can pmail me this information to email99@nc.rr.com .
I am investigating a low cost alternative that I will discuss after I do a little more research. Thanks all, Ed |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.