Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2019, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 12 Apr 2019 14:03:13 -0400
Reply-To:     Steven Johnson <sjohnso2000@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Steven Johnson <sjohnso2000@GMAIL.COM>
Subject:      Re: Rearview Camera Cable Routing
Comments: To: Dan N <dn92610@gmail.com>
In-Reply-To:  <CAFdLW6nELfi2Ues8KC1VW75cS0z40x=tC9cMT6pcDk77342d=w@mail.gmail.com>
Content-Type: text/plain; charset="UTF-8"

This is a navigation/rearview/front view camera from Tomtop. The cable is a 5 pin that seems specific to this model. If I could figure out how to adapt it to the wireless ones I'd do it but I have no idea which pin is which nor where I'd get an adapter to make it work. So I'm routing the cable. I think the tough part is over. I've had this mirror/nav system for about 2 years now and am just finally getting the rearview part finally hooked up. Just one of those things hanging out there for me to get to. To many things on my to-do list....

Steven 91 Westy

On Fri, Apr 12, 2019 at 1:52 PM Dan N <dn92610@gmail.com> wrote:

> you got it... nice... > > for those who want a rear view backup camera... some of them are wireless > ... > I wonder if they as good as the wired ones? > > On Fri, Apr 12, 2019 at 10:43 AM Steven Johnson <sjohnso2000@gmail.com> > wrote: > >> Hi All, >> >> Well, my solution involved Dawn dish soap. I lubed the electrical A/C >> bundle shield with the dish soap, >> taped up the plug tip and swabbed some dish soap on it as well and fairly >> easily passed it through the >> opening between the engine compartment and the bed area underneath the >> drivers side cabinet. Glad >> I didn't have to drill another hole. I tie wrapped the engine side to >> the fuel rail (not real tight) and left it >> for now. I want to test it again to make sure the video feed is still >> good and not mangled. The remaining >> other end of the cable is just sitting tie wrapped at the ceiling. I'll >> route that after I've checked the video >> again. >> >> Thanks everyone for your valuable input! >> >> Steven >> 91 Westy >> >>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.