---------- Forwarded message --------- From: David Beierl <dbeierl@attglobal.net> Date: Thu, Apr 18, 2019 at 12:17 AM Subject: Re: Oil buzzer won't stop To: thewestyman <zolo@foxinternet.net> Cc: vanagonlist a <vanagon@gerry.vanagon.com>
Have you done the obvious thing -- tested the pressure with a gauge? Yrs, d On Thu, Apr 18, 2019 at 12:08 AM thewestyman <zolo@foxinternet.net> wrote: > Hi guys, > > I thought, I have done all I could. But that’s not enough. > > I did change both senders, the 0.3 bar between the tubes, and the 0.8 bar > one behind the pulleys. > Checked the continuity of the brown wires that lead to the wire box, and > they have continuity. The wires’ ends are new. I have renewed most of the > two wires. > The 0.8 bar sender’s wire goes to the yellow/black wire. Both wires have > continuity up at the round connector. > > If I accelerate over 2000 the buzzer goes off. The engine runs fine with > the new gasket I just installed. > It must have been badly overheated before it came to me. > > There must be something else that makes this happen. > > Maybe David has an idea. Because I think, it can happen to anybody. > > Zoltan > God bless the List > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.