Date:         Sun, 30 Jun 2019 12:16:51 -0700
Reply-To:     Neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Neil N <musomuso@GMAIL.COM>
Subject:      Re: Some dometic notes
Comments: To: Alistair Bell <albell@shaw.ca>
In-Reply-To:  <B0F81385-6BC7-4388-817A-1C4C2269B26C@shaw.ca>
Content-Type: text/plain; charset="UTF-8"

Thats useful to know; I'm sure I wasn't the only owner-operator to
have misaligned the intake and exhaust tubes a little during fridge
removal, re install.

The other part to that equation is the O rings that seal the
corrugated intake and exhaust tubes to the (aluminum?) manifold. It
was likely a needless thing to do, i.e. the OE rings might well have
been fine, but I installed new Viton O rings on those corrugated pipes
but was never absolutely certain they were butting right up against
the lip inside each opening at the manifold. I measured things with a
set of callipers but.....

Image of manifold "lip"

https://tinyurl.com/y4trgtb5

Neil.

On 6/30/19, Alistair Bell <albell@shaw.ca> wrote:

> One thing about the exhaust, apart from having good gasket and seal, there
> is enough meat on the metal to re tap next simple up, for the machine screws
> that hold the exhaust and intake ends onto the stainless vent assembly.
>
> Those screw holes can get wallowed out.


-- 
Neil n

VE7TBN

1988 Westy 50º ABA swap: https://tinyurl.com/yap5hpwt

1981 Westy 15º ABA swap: https://tinyurl.com/y9n4xob8

VAG Gas Engine Swap Group <http://tinyurl.com/khalbay>