> > > I would have to agree; the thermocouple in the burner box is basically > an "on off" type device that serves only to keep the shut off valve > open. But...... > The thermocouple output is proportional to temp difference between the two junctions. But the output is either enough to hold the gas valve open, or not. Certainly an eroded one is on the way to failure.
> Maybe a lower voltage from the thermocouple would only pull the valve > part way open? > No, it can't pull the valve open at all, only hold it open. The thermocouple is basically two pieces of wire, so it has ridiculously low impedance. That means that its tens of millivolts output can push IIRC better than one ampere through the magnet in the gas valve, which is only a few turns of heavy wire with pole pieces that are machined flat. The actuator piece is also machined very flat, so that it makes extremely good physical contact with the pole pieces. Because of the close contact the magnetic circuit is very good and the valve can be held open with considerable force. But that force vanishes as soon as the two pieces break contact, so the valve has to be opened by you "pushing the pickle".
> > I *think* that the "silver" narrow tube going from the thermostat to > the cooling unit in fridge is, in part, responsible for sensing if > more cooling is needed hence a larger flame is required. As I'm sure > you know, there is a small white silicone or rubber bit that keeps > that tube pushed up against the aluminum cooling unit. > The thermostat is a snap-action device operated by that capillary tube. When it calls for cooling, it opens a clear channel for gas to pass through and be limited by the orifice. When it does not, the gas for the pilot flame is metered through an extremely small orifice inside the gas valve. The flame has only two levels; cooling and pilot. Yrs, d |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.