1977 Baywindow, 2 liter, Fuel Injected.
I installed new LED bulbs for my parking/brake, backup, and turn signals. Lighting is MUCH improved. I even added silver reflective HVAC tape on the inside of the light boxes.
All work well, and the turn signals blink rapidly-as I pretty much expected they would.
Suggestions on thesamba was to install a 470 ohm resistor to cure the rapidly blinking turn signals. What is the easiest way of doing that?? I thought about adding a resistor, inline between a male and female spade, and then patching that in right at the turn signal. I am thinking that it has to be done on both sides? Electrical is not my strong point-and I may be totally off base, so don't laugh to hard.
Any suggestions.
Thanks stab |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.