Thanks Dennis. Helpful info. IIRC, the GoWesty upper control arm bushings may require similar adjustments. The bushings supplied by T3 may not? I may just go with Whiteline bushings from T3 Neil. On 1/19/20, Dennis Haynes <d23haynes57@hotmail.com> wrote: > I installed a set of these just before the holidays. Had to change the > eccentric washers to set the pre-load. The inner sleeves are a slightly > different length so thinner eccentrics were needed. > > Dennis > > > -----Original Message----- > From: Vanagon Mailing List <vanagon@gerry.vanagon.com> On Behalf Of Neil N > Sent: Saturday, January 18, 2020 3:16 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Nolathane upper control arm bushings? > Anyone installed these Australian Nolathane REVO420086 Upper Control Arm > Bushings
-- Neil n VE7TBN 1988 Westy 50º ABA swap: https://tinyurl.com/yap5hpwt 1981 Westy 15º ABA swap: https://tinyurl.com/y9n4xob8 VAG Gas Engine Swap Group <http://tinyurl.com/khalbay> |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.