Posted my solution to adding back up cam rear view mirror on my blog https://shufti.blog/2020/03/23/vanagon-digital-rear-view-mirror-mount/ I say in the blog post, but I’ll say again here. Take this as a starting point for improvement. I didn’t spend much time on it and I know it can be made better. But that said, it does work fine and is not bad looking when installed. I’ll also repeat what I said in blog in that it’s a good candidate for 3D printing project. You out there who know your printers and plastic choices could make this idea better. I’ve made the fusion 360 files downloadable. Alistair |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.