Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2020, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 29 Mar 2020 12:26:26 -0700
Reply-To:     Alistair Bell <albell@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alistair Bell <albell@SHAW.CA>
Subject:      Re: Engine died up date
Comments: To: vw_van_fan_Mark <madvws@cox.net>
In-Reply-To:  <aaf9f0a5-f049-cc0c-d801-92a535928e7c@cox.net>
Content-Type: text/plain; charset=utf-8

Right mark. Glad to get info.

Just posted update on ecu plug testing. Looks like pin 19 not getting grounded

Ab

> On Mar 29, 2020, at 12:22 PM, vw_van_fan_Mark <madvws@cox.net> wrote: > > Power from the key switch feeds over the black wire to power the coil. > The thicker green wire is from the ECU, connected to a transistor in the ECU that switches ground on and off on the green wire to fire the coil when the ECU sees hall pulses. > > There is a second black wire attached at the same place on the coil that shares the key-on power feed with the fuel injection relay box to turn on the ECU power relay. The relay controls the real power that comes from the red wire power stud in the engine compartment wiring box. > > There is a second green wire attached at the same place on the coil and this feeds to the dash instrument cluster for use by the dynamic oil warning board as well as the tachometer. > > Residual pressure in the fuel loop is expected for hours/days and seeing fuel gush once at the bleeder screw isn't much proof of current fuel delivery. If you turn the key on/off a few times and then again have a fuel gush when you loosen the screw then that proves that new fuel pressure has been supplied since the last pressure release. > > A single screw holds the injector pairs to the manifold and if you remove an injector pair you can visually verify injection fuel pulses by turning the distributor as described previously. Be aware of fire danger while doing so. > > Mark > > > > > Alistair Bell wrote: >> Just did a couple tests >> >> Fuel line tee beside dizzy. Loosened bolt and did get spurt of gas. So gas gets that far at least. >> >> Jumped between black box pos distribution stud and alternator, no change >> >> I do have 12 at both the green wire side and black wire side of coil. I mis spoke earlier about what wires fo to ecu, it is of course the fatter green wire. >> >> Confirm alternator light stays on during cranking. No movement on tach >> >> Still no gas smell from tailpipe >> >> Next is to examine ecu , esp the ecu ground . >> >> Thanks again for all the suggestions >> >> Ab >>


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.