Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2020, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 15 May 2020 17:43:22 -0700
Reply-To:     David McNeely <davmcneely40@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David McNeely <davmcneely40@GMAIL.COM>
Subject:      Re: Leaky rear heater
Comments: To: Dennis Haynes <d23haynes57@hotmail.com>
In-Reply-To:  <MN2PR08MB623950F759C390CA7EA1965FA0BD0@MN2PR08MB6239.namprd08.prod.outlook.com>
Content-Type: text/plain; charset="UTF-8"

Given that I rarely have rear seat passengers, and even less often in winter, when the darned thing kept finding more and more ways to leak, I just removed it, and freed up some additional storage space.

mcneely

On Fri, May 15, 2020 at 4:01 PM Dennis Haynes <d23haynes57@hotmail.com> wrote:

> A leak from the rear heater is one of the nastiest failures to happen > inside a vehicle, worse in a Westy. The coolant will go under the floor of > the cabinet and travel back and forth in the channels of the floor pan. The > only way to really clean it is to remove the rear bench and floor. As a > quick attempt to clean the mess jack the front up and then use a wet vac to > suck up the coolant that flows back under and to the rear of that seat > cabinet. The common failure are the heater core itself, the valve, the > valve flange gasket, and my favorite the top snapping off the bleeder! That > bleeder is not needed, the rear cores bleeds itself easily, replace with a > M8X1.0 screw glued and sealed into place. > > The core itself fails in two ways. The thin tubes actually erode from the > coolant passing through it and the end cap gaskets fail. The replacements > are junk so learn to insect often. Luckily this one is easy to get at. When > not in heating system keep the valve closed. This reduces flow and the > thermal changes that help tear these up. Consider one of industrial or big > rig diesel coolants that don’t use abrasives as part of the corrosion > control scheme. > > Dennis > > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf > Of Jeff Palmer > Sent: Friday, May 15, 2020 4:25 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Re: Leaky rear heater > > It’s gotta be the valve. Argh! > > > On May 15, 2020, at 3:18 PM, Jack R <jack007@comcast.net> wrote: > > > > I went with the GW valve, and new core last year when I did my 84 Westy. > > https://nam11.safelinks.protection.outlook.com/?url=https%3A%2F%2Fwww. > > gowesty.com%2Fproduct%2Fcooling-system-%2F24275%2Fgowesty-rear-heater- > > core-valve&amp;data=02%7C01%7C%7Cb3ee8872b691464e484908d7f90e2359%7C84 > > df9e7fe9f640afb435aaaaaaaaaaaa%7C1%7C0%7C637251711431947984&amp;sdata= > > EgaGwKuemmqprDAWAs3cQ%2FwCfGfPo5X0BtrGfaUboys%3D&amp;reserved=0 > > > > No leaks, no smell, plenty of heat! > > > > -----Original Message----- > > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On > > Behalf Of Eric Caron > > Sent: Friday, May 15, 2020 2:58 PM > > To: vanagon@GERRY.VANAGON.COM > > Subject: Re: Leaky rear heater > > > > Yes, it was not fun to clean up. But the valve isn’t usually replaced > along with the core. The core does not come with a new valve in may > experience. > > > > There are some plastic tabs in the floor. They can be removed to help > with drainage and cleaning. I removed mine on list recommendation to > prevent future coolant mess. I should check them but at the time I duct > taped them and put water drainage holes too small for mice. > > > > Eric > > > > > >> On May 15, 2020, at 2:43 PM, Bruce Todd <beeceetee@GMAIL.COM> wrote: > >> > >> Could it be the mechanic didn't mop up all the old coolant seeping > >> around under the back bench - seems to me the floor of the box around > >> the rear heater is concealed by thin particle board and hard to clean > >> underneath it > >> - perhaps coolant could have been hiding under the heater or particle > >> board and then shifted / flowed to a visible area? > >> > >> Bruce > >> > >>> On Fri, May 15, 2020 at 7:35 AM Jeff Palmer > >>> <w.jeff.palmer@icloud.com> > >>> wrote: > >>> > >>> Hi everyone. I had my rear heater replace a few weeks ago after > >>> noticing the smell of coolant. Didn't notice any leaks, until my > >>> mechanic told me he saw coolant dripping from the body. It must > >>> have been a pretty small leak. > >>> > >>> > >>> > >>> It's been running fine with no smell since replacement but the other > >>> day i found a puddle on the ground underneath the rear bench area. > >>> I took the cover off and keep expecting to see it sitting there in a > >>> puddle of coolant but nothing. Is there anywhere else it might be > >>> leaking if it's not the heater itself? > >>> > >>> > >>> Thanks > >>> > >>> Jeff > >>> > >>> 85 Westfalia > >>> > >>> >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.