Hi All, Taking a chance here. (Friday) I'm trying to extract a roll pin that has a diameter of about 1/16th inch. from a rod that is about 1/2 - 1/3 inch. I'm having a devil of a time getting it out as it is part of a vertical blind that is about 16 feet long. I'm trying not to take the blinds down. So I'm working at an awkward angle with very little leverage. I've tried knocking it out with no success. The dremel bits I don't have the umf needed to muscle through it. I'll probably got the hardware store for some carbide bits but I wanted to run this past the list just in case someone here has any clever ideas... Thanks, Steven 91 Westy |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.