Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2020, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 1 Jun 2020 05:41:31 -0400
Reply-To:     FRANK CONDELLI <ralanen@AOL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         FRANK CONDELLI <ralanen@AOL.COM>
Subject:      Re: leaky windshield
Content-Type: text/plain; charset=utf-8

I have replaced many windshields using the original seal and new seals. NO sealant is needed to make a water tight install, period ! If there is a leak there is a problem with the frame or the seal. The frame is either rusted or was rusted and repaired poorly and is out of it’s proper configuration. The metal lip that the seal sits on must be in perfect original condition. The seal must be installed with a good lubricant to allow it to sit down on the metal lip and make a watertight seal. I use KROWN <https://www.krown.com/en/> rustproofing oil applied to both the metal lip and the rubber seal. It serves three purposes, stops rust if there are any unpainted, unprotected metal surfaces, allows the seal to slip into its proper position without undue force and keeps the rubber supple. Since you are so far from the installer you need to have someone local remove the windshield and seal without naming the seal (this IS possible, I have done it many times) then photograph any areas that are not correct and try to get compensation from the shop that did the original install. The new installer must be aware of the problems related to these Vanagons. Leaking in the bottom corners is VERY common due to a variety of reasons. The installer must be aware of this and know how to repair the problems, not just install the windshield !

> On Jun 1, 2020, at 12:00 AM, Automatic digest processor <LISTSERV@GERRY.VANAGON.COM> wrote: > > Re: leaky windshield

Cheers,

Frank Condelli Almonte, Ontario, Canada '87 VW Westy, '00 Kawasaki 250 Sherpa, "98 Ducati 750 Monster Frank Condelli & Associates <http://www.frankcondelli.com/> - Vanagon/Vanagon Westfalia Parts BusFusion <http://www.busfusion.com/> a VW Camper camping event, Almonte, ON, June 11 ~ 14, 2020 Lionel Trains (Collection for sale <http://www.frankcondelli.co/trainsal.htm>)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.