I have the GW Dual nozzle windshield washers to replace the old ones that seem to be partially closed and do not cover the entire windshield all that well Looked so simple on the website instructions BUT I was not able to remove the old ones as per the video instructions
I used channel locks to get a good grip pulled as had as I could … wiggled etc etc Neither one would budge .. Thinking well I am getting old and weak had two younger guys who are gym types again to no avail https://www.gowesty.com/product/wiper-washer/24156/dual-nozzle-windshield-washer-jet-?v= I did try inserting a very small screw driver while some one else was pulling …. hoping to depress or break off one of the tabs the are keeping it in did not work Any one out there with a solution
thanks ed Edward V Barger edvbarger@yahoo.com 310 922 6251 “Age is an issue of mind over matter … If you don’t mind it doesn’t matter " Mark Twain |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.