Hi folks, So, I’ve now serviced both slider window latches and am happy with the results. I had mentioned having a flat head screw driver bent on two sides that allowed for the access to the screw under the latch. That worked for the passenger side but the driver side has less clearance due to the stove top. I found that I could remove that screw or adjust it much easier by simply taking a flat head screw driver head, like the ones used in a cordless drill. Then use a small wrench to turn it while holding it up with a finger. This was so darn easy compared to the other tool. So, if you want to tighten or loosen that spring or fix the latch from moving that is the tool I’d recommend! Man, I wish I could think of these tricks at the start of a project! But, window latches nice and tight now! Eric Caron |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.