Date: Sun, 4 Jul 2021 11:01:48 -0400
Reply-To: Eric Caron <ericcaron96@COMCAST.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Eric Caron <ericcaron96@COMCAST.NET>
Subject: Re: Any Guesses ~~ Now For Sure Your Turn Please ~ Update
In-Reply-To: <4B75009E-BA5E-4E01-9ADC-408BB61A346A@comcast.net>
Content-Type: text/plain; charset=utf-8
I really enjoy these threads of problem solving!
Eric Caron
> On Jul 4, 2021, at 10:43 AM, OlRivrRat <OlRivrRat@COMCAST.NET> wrote:
>
> Issue Resolved I Think,, As Of 7:30 Last Eve’ > But Not going to say for sure ’til I
>
> start it this Morn & it still runs fine ~ Will report on Fix as soon as I'm sure it is Good ~
>
> ORR ~ DeanB
>
>> On 2 Jul , 2021, at 8:24 PM, OlRivrRat <OlRivrRat@Comcast.net> wrote:
>>
>> So 1st a Correction to previous note > I had intended to check those PwrSteering Wires
>>
>> when Van arrived back in ABQ but apparently didn’t as now that the Van has gotten back for
>>
>> My attention it is pretty obvious that the DC+ of those 2 was the culprit > It was Dangling &
>>
>> missing 8-10 Inches of Its insulation ~ Owner had Power Washed Eng’ before heading out of
>>
>> Roswell that Morn’ that the WireFry happened & I suspect that that wire got blown off during
>>
>> that Wash & ended up connecting to ground ~
>>
>> Removed Bad Harness day before Yesterday & Yest’ Morn’ installed known good harness
>>
>> that I had taken out of a Westy a few Years ago so as to install a GW EFI & also a spare ECU &
>>
>> Idle Control Relay just incase ~ For a few hours it would not start so during that period I tried
>>
>> 4 diff’ ECUs & 2 Diff’ ICRs > Crank No Start ~ I was on My own so had no way to see if a Spark
>>
>> was happening but finally got an assist’ & determined No Spark ~ All Volt's to Igni’ & Fuel Sys’
>>
>> seemed to be correct & Coil checked out OK so thought I would swap in a spare Dizzy incase
>>
>> the Hall Sen’s had been damaged somehow & it Came To Life but wasn’t running properly ~
>>
>> Assuming it was probably Off Time due to Dizzy Swap I shut it down & took a short break ~
>>
>> With T’Light all hooked up & @Ready, turned key & No Start ~ A couple of hours later it again
>>
>> FiredUp & Timing got done & then it quit & NoStart ~ This Morn’ it Fired Right Up & idled @
>>
>> about 1400rpm for for about 5mins & quit when I attempted to give throttle ~ Couple o hours
>>
>> later after acquiring a spare Coil & another Dizzy (but not installing yet) It again started & ran
>>
>> & had smooth power as long as I kept above 2K RPM but died when allowed to attempt idle &
>>
>> again no start ~ Swapping in Spare Coil & Dizzy has produced No Joy ~
>>
>> AnyBody have Any Ideas where to look next ~
>>
>> ORR ~ DeanB
>>
>>> On 15 Jun , 2021, at 10:16 PM, OlRivrRat <OlRivrRat@Comcast.net> wrote:
>>>
>>> When the Van arrived back in ABQ, that was 1 of the things that I looked @ 1st as I had just
>>>
>>> replaced those connectors a few months back due to their dilapidated condition & closeness to the
>>>
>>> the intake plumbing ~
>>>
>>>> On 15 Jun , 2021, at 7:36 PM, vw_van_fan_Mark <madvws@COX.NET> wrote:
>>>>
>>>> The usual cause of that 2.1 injection harness damage is a shorted wire
>>>> to the power steering pressure switch.
|