Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2022, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 23 May 2022 15:51:13 -0700
Reply-To:     Alistair Bell <albell@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alistair Bell <albell@SHAW.CA>
Subject:      Re: Westy Tap
Comments: To: Eric Caron <ericcaron96@comcast.net>
In-Reply-To:  <666EAF81-7287-4593-A1AE-78840450C633@comcast.net>
Content-Type: text/plain; charset=utf-8

Sorry Eric, I missed that :-)

Ab

> On May 23, 2022, at 3:36 PM, Eric Caron <ericcaron96@comcast.net> wrote: > > It is a sure flow so I think the contacts there are good. > > Still working consistently now that aux battery is topped off. > > Eric Caron > > >> On May 23, 2022, at 3:30 PM, Alistair Bell <albell@SHAW.CA> wrote: >> >> Have you checked the switch inside the tap? Phillips screw in knob top, knob lifts off. Electrical contacts under. Don’t yank the knob up hard, be gentle. >> >> That area gets wet and the contacts can corrode >> >> Alistair >> >>>> On May 23, 2022, at 9:06 AM, Eric Caron <ericcaron96@comcast.net> wrote: >>> >>> Stumped, >>> >>> Changed my pump, issue was only turned on every now and then. >>> >>> I could feel slight movement when switche at the sure flow turned on. >>> >>> New pump, went on once then same behavior except only small thump and no water. >>> >>> I changed the fuse and same result >>> I checked wire connections same result. >>> >>> Any thought on next steps? >>> >>> Gill are we in a similar situation? >>> >>> Eric Caron >>> >>> >>> >>>> On May 23, 2022, at 8:38 AM, Eric Caron <ericcaron96@COMCAST.NET> wrote: >>>> >>>> So back to the original question. The pumps are not expensive change it out and likely you will have better pressure and know quickly if the issue is the old pump. I think it is good to set up a longer wire as I described to make access easier and it makes changing the pump wiring so much easier. Just leave the original wire connected in the tight space and use the old pump wire as a extension. Then connect the new pump to the matching wires on the old pump wire. >>>> >>>> Eric Caron >>>> 85 and 84 Westfalia. >>>> >>>> >>>> >>>>>> On May 21, 2022, at 10:50 PM, Gil Ngai <eyebawlgil@GMAIL.COM> wrote: >>>>> >>>>> Hey all, >>>>> My sink tap makes a motor noise like it’s trying to get water from the tank but no water comes. The tank is half full. Is that the pump that’s broken? >>>>> >>>>> Gil Ngai >>>>> 85 Westy 2.5EJ >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.