Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2022, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 20 Jun 2022 13:42:57 -0400
Reply-To:     "kenneth wilford (Van-Again)" <kenwilfy@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "kenneth wilford (Van-Again)" <kenwilfy@COMCAST.NET>
Subject:      Re: Manual Trans complete axle?
Comments: To: Eric Caron <ericcaron96@comcast.net>
In-Reply-To:  <539BE121-EAD5-4869-8983-B7177B96BE8B@comcast.net>
Content-Type: text/plain; charset="UTF-8"


We have a few of these left in stock also.
https://www.vanagain.com/product/vanagon-cv-axle-for-manual-transmission-vanagons


It looks like 3 left in the country for the manual GKN axles.


Ken


On Mon, Jun 20, 2022 at 12:04 PM Eric Caron <ericcaron96@comcast.net> wrote:


> Is that different then these two links?  I think it says out of stock on
> both of these but my screen reader could be saying something wrong or about
> a different product.
>
> https://www.autohausaz.com/pn/GK-251501203GX <
> https://www.autohausaz.com/pn/GK-251501203GX>
>
> https://www.rmeuropean.com/Products/251501203GX-MFG60-V2620.aspx <
> https://www.rmeuropean.com/Products/251501203GX-MFG60-V2620.aspx>
>
> Eric Caron
>
>
>
> > On Jun 20, 2022, at 11:42 AM, christopher@t3technique.com <
> christopher@T3TECHNIQUE.COM> wrote:
> >
> > AZAutohaus had a GKN unit late last week.
> >
> > Christopher
> > T3 Technique
> >
> >> On Jun 20, 2022, at 8:33 AM, Eric Caron <ericcaron96@comcast.net>
> wrote:
> >>
> >> Hi folks,
> >>
> >>       I just found a ripped boot on my 84 manual trans.  I’d much
> rather change out the full unit then rebuild a spare later.  But, the
> sources shared in the past both seem to be out of stock.  I’m not a good
> internet searcher.
> >>
> >> Anyone have a link to a source that still has them in stock?
> >>
> >> This is the manual Axle with CV and Boots, greased and ready to install.
> >>
> >> Thanks,
> >>
> >> Eric Caron
>




-- 
Thanks,
Ken Wilford
John 3:16
www.vanagain.com
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.