Date:         Sun, 31 Jul 2022 17:49:22 -0500
Reply-To:     Jeff Palmer <w.jeff.palmer@ICLOUD.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jeff Palmer <w.jeff.palmer@ICLOUD.COM>
Subject:      Re: Getting ready to paint
Comments: To: Jack R <jack007@comcast.net>
In-Reply-To:  <008401d8a525$11fd1000$35f73000$@net>
Content-Type: text/plain; charset=utf-8

This helps for sure! Thank you. I won’t be doing the painting so will count on the professional advise I get from the painter but this is something I hadn’t considered. 

I was thinking I would start to order gaskets, trim etc in advance as I don’t know that I would expect the painter to do that. 

I see that body panels are also available and wondering if I should replace them as much as possible. Or am I replacing somewhat rusty panels with new junk?? When the van was younger it was driven all year in Canadian winters. 


Thanks again!
Jeff

Sent from my iPhone

> On Jul 31, 2022, at 4:33 PM, Jack R <jack007@comcast.net> wrote:
> 
> Jeff,
> 
> I assume you are going to media blast before paint?  If so, I will caution you to COVER everything!
> I had blast media make it into the bell housing, then to my rear main seal... 
> 
> Also, I did what you are planning, replaced nearly all the bad metal I could get panels for.
> 
> We pulled ALL the window glass as well, and despite that effort, 10 years later I did have a few spots of rust come through around the window above the sink-cabinet (outside of course)
> 
> Lastly, make sure the painter uses a good epoxy enamel primer, to seal the metal, before base coat and top coat.
> For the base coat we used PPG Deltron 2000/DBC.
> 
> Hope this helps!
> 
> Jack
> 
> 
> 
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Jeff Palmer
> Sent: Saturday, July 30, 2022 6:25 PM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Getting ready to paint
> 
> Hi everyone. Sometime soon I will hopefully be painting my 85 Westfalia. Does anyone have a list of parts I would need - trim, gaskets, etc. 
> 
> Also wondering if I should order every sheet metal panel I can find … things get rusty up here. 
> 
> Thanks
> Jeff
> 
> Sent from my iPhone=