Date:         Sun, 23 Apr 2023 21:27:24 +0000
Reply-To:     David Boan <dboan@OUTLOOK.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Boan <dboan@OUTLOOK.COM>
Subject:      sliding door seal
Content-Type: text/plain; charset="us-ascii"

Hi Vanagon Types

I am replacing my sliding door seal and have a quick question, in case anyone who has done this has some tips.

I have the GoWesty seal and it appears to fit quite well. I found suggestions online about doing the corners first, dry fit before using glue, etc, but not how to handle the fact that it is a continuous loop.

So, my question is about handling the continuous seal. It appears I either have to unbolt the slider or cut the seal. I am afraid I will create more trouble if I unbolt the slider, so I am leaning toward cutting and then gluing the seal. Does that seem right? If I cut it, is it better to have the joint toward the back, perhaps in the middle of the rear side?

Thanks in advance for any suggestions.

Dave B
Boise
'85 Westy