Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2023, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 3 Sep 2023 21:56:54 +0000
Reply-To:     Richard Koerner <rjkinpb@SBCGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Richard Koerner <rjkinpb@SBCGLOBAL.NET>
Subject:      Re: A trick - Subiegon oil dip stick
In-Reply-To:  <CA+az7_5LpqYa4cnpvCKTou5URyMJ4kGh0KBziez6p5yYBx6PkA@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8

I bought the Small Car plastic oil dipstick for Subie 2.2; my issue was that it was sometimes hard to discern the 2 scribe lines indicating upper and lower levels.  I did this:  found some stranded copper wire, stripped off an appropriate length, just using 1 strand.  Enough to make 3 turns.  Cinched tightly around the plastic tube, twisted to insure hoop tension.  Got out soldering iron; just a little solder on the copper to form a "band".  This action causes copper to heat up, imbedding itself on the plastic OD.  Trimmed off, and filed smooth.  Works great, easy to see proper marks in all light conditions.  Some folks were apprehensive of me doing this, for fear of copper band sliding off.  But after 4 years, the copper bands are very snug and secure and nicely imbedded.  And makes life easier.

On Sunday, September 3, 2023 at 10:50:26 AM PDT, John Rodgers <jrodgers113@gmail.com> wrote: Anyone who has a Small Car plastic oil dipstick knows they can be fiddly, but it is nice to be able to check the oil level without having to move everything out of the rear hatch area just to get to the stock dipstick. But that plastic tube is a major PITA!

There are two oil level rings marked on the plastic tube. You definitely want to add oil when the oil is at the low level mark. Trying to check oil and get that tube back in, I managed to break that tube right at the lower ring. That is a weak spot. Turned out to be good fortune. I put it in the oil tube and it went in easily. No more fiddly. As long as there was oil  anywhere in that plastic tube up to the top mark I was good. IF oil didn't show, add oil until it showed up the tube again. If oil just barely showed, it would take one quart.

That little adjustment made having a Small Cars oil tube worth it.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.