I’m late to this and I should have spoken up earlier. Cos… I’ve had my door handles on and off a lot while developing my machined handle replacement. I only use the big screw in that handle. The smaller outboard screws eliminated. The big screw, I’ll give you it in inch measure: It’s a pan head,, Phillips drive, full length thread Head diameter 0.484” Overall length 1.434” Length below head 1.255 Threaded major diameter 0.241” Minor diameter ( rough) 0.188”
Hope this helps at hardware store
Alistair |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.