I'm getting ready to remove my gas tank and the 2 Vapor Expansion Tanks in wheel wells (because some welding nearby is soon going to occur). My question: what is the proper rubber hose to use? I think it is 7mm ID; I think it is just normal gasoline rated hose, not the high pressure stuff for fuel injection. I think (I don't have my van right now to look at it) is cloth braided on the outside....the only function I can perceive is that the cloth braid serves as some kind of "impact absorber" from all the gravel bits flying up in there. Extra Bonus Question: where do I buy this hose?....I think I only need a few feet of it.....also, why is there a rubber section from Crossover Tube, then a plastic section, then another rubber section? Why wasn't it all one piece? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.