Date:         Sun, 17 Aug 2025 22:25:10 -0400
Reply-To:     Eric Caron <ericcaron96@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Eric Caron <ericcaron96@COMCAST.NET>
Subject:      Re: Replacing rear hinge on sliding door
Comments: To: "smoketoxdoc@icloud.com" <smoketoxdoc@ICLOUD.COM>
In-Reply-To:  <95FA45AD-97FC-4A59-8405-7005B3BCFE5E@icloud.com>
Content-Type: text/plain; charset=utf-8

Hi John,

        it has been some time since I did this.  But, with list help I did this some time ago.  

        Hopefully others will speak up or you can check the archive.

I remember opening the door then propping the rear corner on a dry wall bucket or something with shims to hold it in place.  

        there were three bolts on the inside.  I don’t remember details.  There may be helpful videos on GW as they sell the bearings and likely the hinge coming off is covered. 

I believe I also removed the panel over the rear channel to make it easier to access the hinge. And figure out how the rollers fit on. 

With some care I expect you can do this. 

Eric Caron 
85 GL 



> On Aug 14, 2025, at 6:17 PM, John Lauterbach <smoketoxdoc@ICLOUD.COM> wrote:
> 
> I have a 91 Vanagon. I need to replace rear hinge on the sliding door. Have one on oder from VanAgain.   Can I do this job by myself?  Right now van is in Poincianal, FL, in my girlfriend's garage. With her car moved out have open half of garage to work in.  Suggestions and help appreciate.  John 
> 
> 
> Sent from my iPhone