Randy writes, (among other things) > However, now the starter gaily turns over but the engine > doesn't always start. If it's been sitting for more than > a day or so it won't start. If it sits for about 12 hours > it starts but only after about 20-30 seconds of turning > over. If it's only been sitting for an hour or so, it > starts right up. > > I can still use the run a wire from your solenoid right to > the battery trick and it starts right up every time with > that. Bizarre! > > As the bus is FI, I read somewhere that the FI system needs > a minimum voltage (9.5 volts?) in order to start. What I'm > thinking is that the relay causes more drain on the battery > than before which doesn't allow enough voltage to get to > the FI system. Does that make any sense at all? The > battery is kind of old, my next guess is to replace it. My first course of action would be to *clean the battery connections*! These are the first place that the current must get through to get to the rest of the system, and the most neglected. If the problem persists after the terminals are clean and securely fastened, then get a new battery. I've *never* regretted getting a new battery, 'cause you usually need one anyway, and then you can rule that out as a source of the problem. Also, as far as starter relays are concerned, I had a starter problem recently on my '72 Bug, and after replacing the starter *and* the ignition switch, I discovered that the problem was dirty connectors in the wire from the ignition switch and the starter solenoid! I unplugged them in the course of tracing where the current wasn't getting to the starter relay, and after checking both points in the wire that had connectors, the damned thing worked fine! All I probably would have had to have done was to have unplugged and plugged in both connectors to clean the crap off the connections, but no - not me! I had to replace a bunch of parts that were probably just fine! (But I now have the peace of mind of having a new starter and ignition switch! Rationalize, rationalize...) Remember, the first 2 steps in troubleshooting any electrical system are: 1) Is it plugged in? 2) Is it turned on? If it ain't plugged in, turning it on won't make it work, right? :-) Peace,
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.