>I have the engine out and pistons/cylindars off. Any suggestions how to check >the main bearings with our cracking open the case, I would like to avoid that >if I can. I just want to put some new pistons and cylinders on. > Tim (69 camper)
> "TRUST YOURSELF, IT'S THE ONLY WAY TO FLY" Muir Tim, I don't know of a way to check the main bearings without splitting the case. You can check the rod bearings without opening it up( follow Muir's instructions). How old is your engine? Ever overheat? Why are you replacing the p/c's? Did you drop a valve? My experience ('70 Bus) was with an engine that ate number 3due to detonation caused by overheating. I replaced the p/c's and heads. The rod bearings checked out ok. After reassembling, the engine would seize after driving about 3 miles and would not turn over until it cooled back down. I pulled the engine and split the case. Main and rod bearings were toast. They were marginal at best and the added compression of a new top end sent them over the edge. If you have a lot of miles on the engine or any reason to suspect the bearings, go ahead and do them now and save the hassle of pulling the engine again. Charles Armstrong '70 Bus '69 BMW 1600-2
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.