Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 1995)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 14 Jan 95 20:27:21 -0500
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         walshp@ippdsgi3.nawc-ad-indy.navy.mil (Pat Walsh)
Subject:      Re:  71 Westy- mostly apart

>Chris Bridge writes: >I have one question: >on the case, under the oil cooler, there is stamped "020". I have a hunch >that this means the case is line bored 20 thou. over. Any one know if this >is true, and does anyone have the stock dimension of the mains? I could >then measure and be sure. According to the Bentley for that year, the bores for main bearings 1, 2, and 3 are 65.00-65.02mm (2.5590-2.5598in) and number 4 should be 50.00-50.03mm (1.9685-1.9696in). Hope it helps.

Pat Walsh, '71 Westy, walshp@ippdsgi3.nawc-ad-indy.navy.mil


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.