a la David Schwarze: >The "1835" engine has the same case as a 1600, just with bigger pistons and >cylinders (and a stroker crankshaft? Damn, I can't remember!). In other >words, the mounts would be the same. In fact, you wouldn't even have to >get a different engine, just buy the parts and install them onto your >present engine... Would I need, say, a garage full of large red tool chests and heavy equipment to pull this off or is this something that is more or less part replacement? I've never dropped the engine in a bus (or actually anything larger than my lawn mower), so I am speaking from my wealth of inexperience here, but I thought there was some machining involved in the big bore beefups. Any good novels/resources/FAQs about this kind of job out there? Chris '69 Camper
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.