I was thinking I might go buy some tools soon and wanted some advice. I have been getting by with a little help my friends but it has to stop. I am busy working and saving money so that I might buy a new motor. I am planning right now on building this myself. They have, at Sears, this huge metric set for something around $100. Just sockets and ratchets if I remember. It has 1/4", 3/8" and 1/2" ratchets. This seems like a better deal than the mongo huge sets with metric and american sizes. Yes? Also, what should I have in the way of open-end wrenches. I already have the 6-14mm sizes. Finally, I will need a torque wrench. Assuming they come in sizes, what size drive do I want for this? TIA, Jim -- James A. Brill Jr. \\ // jbrill@unlinfo.unl.edu \\ \\// // If you're not outraged University of Nebraska \\//\\// you're not paying attention. free-lance homo sapien \/ \/
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.