>How can I tell if the input shaft is very slightly bent? Wouldn't there be >some difficulty shifting gears? Wouldn't there be vibration and noise? I >haven't noted any of these symptoms. I strongly suspect that the lazy >bonehead of a previous owner caused the damage to my Bus's clutch by not >installing the upper bellhousing bolts that secure the engine to the >transaxle. With the engine out, jack up one wheel and turn that wheel. The trans shaft will turn, anrd will wobble if bent. Chris Bridge Currently building an engine for a ''71 Westy (Sportsmobile?) E-mail cbridge@vt.edu
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.