I got a question: how close do you balance the conn rods and pistons? I have about 15 grams difference in the conn rods which is too much, but I read that only 8grams can be removed safely. I had 3 pistons within 1.5 grams, and one which was 10 grams heavier. I got them all to within 5 grams, but I was wondering if metal could be removed from the wrist pins. It takes a whole lot of filing to get 5 grams off a piston. steel is much heavier. any advice? Chris Bridge Currently building an engine for a ''71 Westy (Sportsmobile?) E-mail cbridge@vt.edu
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.