Well, my motor is going together very well, and I am at the oil cooler stage. The problem is that I can not figure out which seals go where. The thinner ones seem to go between the cooler and the mounting bracket, but the thicker ones don't really fit between the bracket and the case. Is it possible that I should have all thin ones? I think I took out all thin ones, and the mounting bracket sits flush on the case. The other possibility is that there are spacers which are MIA and this would account for the thicker seals. All the seals I am talking about are are about the size of a penny, with a shoulder in them. Another thought: Type 3's have spacers, so they would use the thick ones. maybe there are smaller seals which go between the cooler and the bracket. Does anyone have any pic's which show which go where? Help! Chris Bridge Currently building an engine for a ''71 Westy (Sportsmobile?) E-mail cbridge@vt.edu
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.