Date:         Sat, 4 Mar 1995 08:39:39 -0800 (PST)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         "Thom Fitzpatrick" <thom@tim.com>
Subject:      Re: oil cooler seals

>Well, my motor is going together very well, and I am at the oil cooler 
>stage.  The problem is that I can not figure out which seals go where.  The 
>thinner ones seem to go between the cooler and the mounting bracket, but the 
>thicker ones don't really fit between the bracket and the case.  Is it 
>possible that I should have all thin ones?  I think I took out all thin 
>ones, and the mounting bracket sits flush on the case.  The other 
>possibility is that there are spacers which are MIA and this would account 
>for the thicker seals.

The standard seal kit (from sabo?) has 2 sets of oil cooler seals, for
the two sizes of oil cooler openings.  But if you have a doghouse cooler,
then you need two more of the small ones (7mm).

Thom
-- 
> Man is the only animal that blushes.  Or needs to.
............................................................................
:    Thom Fitzpatrick                             Transamerica Info Mgmnt  :
:  Systems Administrator                          1860 Howe Ave            :
:  tfitzpatrick@tim.com                           Sacramento, CA 95825     :
:   fax (916) 921-6781                            (916) 565-3346           :
............................................................................