> > does anybody know if there are wire brushes (the type that fit in your > ordinary drill) that would fit in a 5" Disc Grinder. Right now i have a > cutting disk on it and would like to outfit it with a bit less abrasive > disk (i.e. the wire brush idea) and strip some surface rust off the bottom > (i.e. undercarrige) of the bus. > > michael > If the grinder uses a standard 5/8-11 (I think) thread brushes should be available most anyhere, they will be about $10 each at normal chain hardware stores but higher quality ones might be cheaper at welding/tool type shops, shop around, these things are great for stripping anything but can really heat the metal up so watch out for deforming the body. John Anderson ja@coe.wvu.edu
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.