Date:         Mon, 10 Apr 1995 18:26:32 -0400 (EDT)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         RGOLEN@umassd.edu
Subject:      Re: Universal Cases

James,

In regard to the universal case, the most important difference between
the Type III case and Type I & 2 cases is going to be the location of
the oil filler/dipstick tube. On the Type III the tube is bolted
onto the case to the right (if you are facing the rear of the car)
of the oil pump. There is a hole slightly larger than a quarter
drilled into the case as well as holes for the two mounting studs.

I guess you could have the case drilled for it. Couple of other 
things...you will need to block off the area where the generator
stand bolts up to the case as well as where the fuel pump would
sit for the Typ 1 & 2s.

Ric

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.