Well, I installed the heads on my 1600 DP and did the torque thing as per St. Muir. Reading over the procedure for installing the rocker arms, Muir says to use gaskets provided for in the gasket kit. I found four "O-Rings" that fit over the studs, but when I disassembled the head there were no gaskets between the studs and rocker arms. Should there have been? The engine ran fine (~15000 since rebuild). Should I put gaskets on? christian [In need of bentley/haynes(?)]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.