Whew! Just got the axles off my old trans. Went at it slow, no brute force. Got the bearings in the reduction boxes out. And tapped out the axles from there tubes. From there it was a piece of cake. Pass. side went alittle easier becuz (1) did the other side first and (2) outer bearing was shot. Ball bearings rolling on the floor as I split the reduction box case. Many thanks for the encouragement.....Now off to find some bearings. christian
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.