When I was wrestling with the bumper this weekend I found a lot of rust on the battery tray on my '71 bus. It has big holes all the way through it. One of the previous owners had laid a piece of sheet metal over the hole and put the battery in there. I do not have the money to do a 'proper' fix. I would like to replace the whole panel. I do have some of that POR-15 rust stopper stuff. I do need to get this air tight or my new motor will suffer. So, any ideas. I was thinking I would remove the previous fix, clean up the rust as much as possible and then apply the rust stuff to stop it there. Then I am lost. Can I lay in a new piece of sheet metal and seal the edges with some high temp silicone sealant or some such? That is the first thing that comes to mind. Any other fixes for this? Thanks, Jim -- James A. Brill Jr. \\ // jbrill@unlinfo.unl.edu \\ \\// // If you're not outraged University of Nebraska \\//\\// you're not paying attention. free-lance homo sapien \/ \/
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.