Dear fellow buspeople, i'm just about to drill the hole into the sump plate to install the VDO oil temp gauge in my 73 bus, and i was wondering: the sender unit has only this copper ring for a gasket, is that gonna be enough ? plus, how about the sump plate itsself...i'm worried it will leak when i put it back in, should i seal it with RTV compound or not ? any experiences (however leaky) out there ??? ciao, gregor WPCHI) HP LaserJet III
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Gregor Durstewitz ============= Oregon Institute of Marine Biology /_| |__||__| :| t+?+ff University of Oregon 0| Festus | t+?+ff Charleston, OR 97420 '+()+++++++()+'
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.