Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 1995)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         February 29, 1992  
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         

Subject:      Vanagon Intermittent Misfire  

CONDITION After driving for 1/2 to 2 hours at a constant speed, vehicle experiences lack of power, cuts-out or stalls, often accompanied by bucking or jerking of the vehicle. In ALL cases, the vehicle will restart immediately. This symptom may not re-occur for several weeks/months. Inspection by the dealer results in nothing conclusive.

Some air-flow meters may experience a vibration resonance of the metering potentiometer wiper during extended constant driving. This resonance causes the air-flow meter to supply an intermittent signal to the Digifant ECU. The ECU will then default to a "no-load" condition and reduce the injection time.

SERVICE Harness, Part No. 025 906 302, is available to resolve this condition. * remove electrical connector from air flow sensor (see Figure 24-174) * install converter assembly, Part No. 025 906 302, between harness and air flow sensor

NOTE If customer complaints persist after performing the above repair, contact your Zone Product Support Specialist (TSM in Canada). ***************************************************************** * CAUTION * * Part numbers are for reference only. Always check with your * * Parts Department for latest information. * **************************************************************** ........................... end ...................................... harness costs about $100! very simple to install. takes about three minutes maximum. the new harness fits between the old harness and the silver air-flow meter box attached to the air cleaner box. remove the silver clip, wiggle out the big wiring connector (from the side of the air-flow meter), connect the proper end of the new harness to the big big wiring connector you just wiggled out, put the new clip into the new connection; then take the other end of the new harness and plug it into the air-flow meter connection. put the silver clip back. and you are done.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.