Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 1995)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 7 Sep 1995 16:07:58 -0700
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         msudul@glenayre.com (Mark Sudul [4590])
Subject:      door roller hooped

Last week my sliding side door pretty much fell off when I opened it. The metal wheel that the lower corner door bracket rolls on had fallen off. I found it with the bearing race, but the bearings were gone. Does anyone know if these bearing can be replaced and the wheel pressed back onto the bracket? Or do I have to get a whole new bracket?

TIA,

Mark


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.