Yesterday will replacing my starter on my 86 vanagon I made a really stupid mistake. I was inserting the small brash bushing that was to be installed before inseting starter it slipped and fall between flywheel and bell housing. So know my guess is is at or near bottom of bell housing. How can I get it out? Do I need to pull transmisson, bell housing, etc?? There is a small plug (1") under transaxle but I assume this is for transmissionfluid. It looked as if there might be small bottom section of bell housing that might come off by itself but now i think its only lines of aluminumn casting. Any ideas?? Anthony
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.