I had a leak down test done on my engine and the results said that the rings and valves are seriously leaking. I am planing to start a rebuilding the engine as so as possible. But what I want to know is there any way to know test if the bottom end is still in good shape before I drop the engine? This engine has low miles, I just bought this van a couple of months ago knowing it had problems but I'm afraid the previous rebuild was a shoddy job. This makes me worry that rebuilding only the top end will not be good enough. I also want to work with a local machinist, Ghent Machine Service is the one a friend recomended. Any suggestions, picks or pans of Seattle area machine shops will be appreciated. Thank You. johnny Stutsman Oceanographer I |Work (206)685-9288 U of Washington |Home (206)784-1254 Sch. of Ocean.;Box 357940 |Fax (206)685-3351 Seattle, WA 98195-7940 |email johnnys@u.washington.edu http://www.ocean.washington.edu/research/sil/index.html
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.