Date:         Tue, 17 Oct 1995 15:54:56 -0600 (MDT)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Jack Reed <jackr@fortnet.org>
Subject:      Emissions (CO) still out...

Hi All,
To all of you that told me that richening the mixture would bring the CO 
down, I say: booshwa.  Richening (dialing in the mixture screw) just sent 
the CO through the roof.  Leaning it out brought up below 1% (spec 1.5%).

The problem I have now is that I can't get it below 2% at 2400 rpm no 
matter what I do.  Any one have any ideas what could be wrong now?  HC is 
good no matter what the rpms.

Any ideas/help/suggestions would be greatly appreciated.

Jack

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.