When I replaced the motor in my 86' with a 90' motor... Well, the 90' motor came out of an auto, so i had to make the necessary changes in order to put it into my manual trans. install: flywheel,set the endplay, install pilot bearing... lots of fun.. when i put the motor in and was pretty for into the switch, i realized that the studs on the bottom of the engine case were about one inch too short and i could not bolt up the bottom too
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.