>>>SSGSPEAR@aol.com said: > In a message dated 95-12-13 18:38:49 EST, (Robinson) writes: > >Does anyone know where I can get the 10mm 12 spline key wrench needed to > >get the driveplate off of a Type IV engine? > Thet're not the easiest things to find. I got mine from the Parts Place, > Inc. in Michigan. I had no trouble *finding* them; I had trouble finding *good* ones. I wrecked 3 K-D versions taking the drive shafts off my Jetta transaxle, then chased and tackled a Snap-On truck and bought one from him. It was worth every penny of the $16 to get a *quality* tool that wouldn't break, or make me go back to the parts store *again*. I figure it's better to by a GOOD tool than make another trip to the store (which is a minumum hour delay, since I have to crawl out from under the car, wash up, drive to the store, drive to the OTHER store that has the part in stock, buy it, go home, drink a Coke, and then go back to work...) So what is this kerch dude babbling about? Bottom line, I recommend you get a Snap-On version of *this* tool. You just won't have any trouble with it. --berry Berry Kercheval :: kerch@parc.xerox.com :: Xerox Palo Alto Research Center
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.