i just hung the drivers door on my bus the other day. it went on fine and even ligned up good. however, when i put the top glass frame on, it would not close. the top frame hits the door post on the upper back portion of the frame. i can get it so that it clears by about 1/16 of a inch, but it is hard to close because of the rubber seal. the front of the upper window fram has about 3/8 of an inch clearance. it seams to me that the whole unit needs to slide forward about 1/4 inches, but there is no way to do that. can anyone out there offer some words of advice? thanks and God BLess matt
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.