|
On Tue, 19 Dec 1995, Frank E. Terhaar-Yonkers wrote: > There is a recall campaign to fix falling down duct work. I don't know > if this include the evap assembly - can anyone comment? > At the risk of shooting my mouth off before I have all the facts in hand, I thought the recall was for the duct work that sits roughly over the middle seats, not specifically for the evaporator bit in the rear. I suppose, though, that one could make a case that if supports on one side of a plastic assemblage break and are covered, then why not supports at the other end? The recall notice was posted by Joel eons ago and should be in the archives. Somewhere. Joachim -- I'm not an engineer, but I play one at work.
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.