Date:         Tue, 26 Dec 1995 08:19:04 -0800 (PST)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Matthew Henricks <mjhenks@engr.csulb.edu>
Subject:      help alinging early bus door

i just hung the drivers door on my bus the other day.  it went on fine 
and even ligned up good.  however, when i put the top glass frame on, it 
would not close.  the top frame hits the door post on the upper back 
portion of the frame.  i can get it so that it clears by about 1/16 of a 
inch, but it is hard to close because of the rubber seal.  the front of 
the upper window fram has about 3/8 of an inch clearance.  it seams to me 
that the whole unit needs to slide forward about 1/4 inches, but there is 
no way to do that.  can anyone out there offer some words of advice?  
thanks and God BLess
matt

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.