Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 1995)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 6 Dec 95 11:20:16 GMT
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         ben@case.co.uk (Ben Ryan)
Subject:      Selecting Gears

> Ben, > > Before dropping the engine, check the shifter linkage at the base of the gear > shift lever. If for some reason you do not have sufficient lateral travel it > would be impossible to select reverse. > > -Bob >

Bob,

Originally i thought it was the linkage but we took it out and it seemed okay. Its not just it won't select reverse but all the gears are a struggle to select. I think it something to do with the gear selector at the front of the tranny, i was thinking of replacing just this front bit and swap the drive shafts. Any ideas would be great!

Cheers,

-Ben Ryan '62 Camper

ben@case.co.uk


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.